IEC 60061 7006-28D-1 Lamp cap not go gauge E40 Finished lamp cap thread minimum outside diameter test
E40 lamp holder gauge
technical standard: G 1483.1-2008; IEC 60061-3:2004
?
| Reference | Dimension/(mm) | Tolerance/(mm) |
| d | 39.05 | +0.0/-0.01 |
| Weight | 0.35kg | ±10% |
| L | 25.0 | +0.0/-0.01 |
| T | 20.0 | +0.5/-0.5 |
| U | 1 | +0.0/-0.1 |
| V | 26.0 | +0.05/-0 |
| W | 2 | ±0.1 |
| α | Approx. 45° | |
IEC 60061 7006-28D-1 Lamp cap not go gauge E40 Finished lamp cap thread minimum outside diameter test
Purpose:
To check the minimum outside (major) diameter of the screw thread.
IEC 60061 7006-28D-1 Lamp cap not go gauge E40 Finished lamp cap thread minimum outside diameter test
Testing :
When the gauge is placed over the thread of the cap on a finished lamp, held cap uppermost, the center contact shall not project beyond surface “X”. Only the weight of the gauge itself shall be used in the test.
IEC 60061 7006-28D-1 Lamp cap not go gauge E40 Finished lamp cap thread minimum outside diameter test
Purpose:
To check the minimum outside (major) diameter of the screw thread.
IEC 60061 7006-28D-1 Lamp cap not go gauge E40 Finished lamp cap thread minimum outside diameter test
Testing :
When the gauge is placed over the thread of the cap on a finished lamp, held cap uppermost, the center contact shall not project beyond surface “X”. Only the weight of the gauge itself shall be used in the test.
IEC 60061 7006-28D-1 Lamp cap not go gauge E40 Finished lamp cap thread minimum outside diameter test
Purpose:
To check the minimum outside (major) diameter of the screw thread.
IEC 60061 7006-28D-1 Lamp cap not go gauge E40 Finished lamp cap thread minimum outside diameter test
Testing :
When the gauge is placed over the thread of the cap on a finished lamp, held cap uppermost, the center contact shall not project beyond surface “X”. Only the weight of the gauge itself shall be used in the test.
?????
所有評論僅代表網友意見，與本站立場無關。